Introduction Numerous thermal management techniques exist depending on the system, application, and power level. For airborne electronic systems, the most direct approach to thermal management would be to use ambient air or chilled air, provided by the aircraft, routed to and blown across the electronics. However, in some applications potential contaminants in the cooling air, … [Read more...]
Synthetic jets for forced air cooling of electronics
Introduction As increasing functionality is packaged into ever-shrinking electronics, cooling requirements rise exponentially. While there have been continued advances in high heat flux technologies [1], commercial, consumer-oriented systems continue to focus on aircooling for reasons of reliability, acoustics, cost and portability [2]. In order to support the increasing power … [Read more...]
Moisture permeation in electronics
Environmental control for electronic packages and enclosures often involves understanding and managing moisture concentration. Excessive moisture combined with processing temperatures can cause damage. High humidity levels have other potentially harmful effects such as corrosion. Since the movement of heat and moisture are similar (i.e., diffusive), thermal engineers may be … [Read more...]
Estimating the effect of intercoolers for computer rack cooling
Figure 1. Four board high rack with serial air flow configuration. Figure 2. Rack with intercoolers cooled by water flowing parallel to air flow direction. In the February 2007 issue of ElectronicsCooling the Calculation Corner article addressed the use of a water-cooled air-to-liquid heat exchanger to reduce computer rack air exhaust temperatures and mitigate the effect of … [Read more...]
Developments with metallic thermal interface materials
Electronics industry needs for improved performance of thermal interface materials (TIMs) are driving continued reductions in thermal resistance. These reductions are being achieved with materials that become liquidous or near-liquidous at predictable operating temperatures, with extremely high thermal conductivity filler materials, or with both. Metallic alloys with low … [Read more...]
- « Previous Page
- 1
- …
- 426
- 427
- 428
- 429
- 430
- …
- 481
- Next Page »
