Measurements of temperature in electronic equipment and in thermal characterization apparatus are most often made with thermocouples. As with any sensor, the goal is to gather information about the environment in the vicinity of the sensor, in this case the temperature. Unfortunately the environment around the entire instrumentation chain, including the lead wires and the data … [Read more...]
Understanding Phase Change Materials
Although phase change materials (PCM) were introduced nearly twenty years ago, it was not until the development of the high-powered Pentium processor that this class of interface material gained widespread acceptance. The large quantities of heat produced by these processors necessitated a carefully designed thermal path where all of the thermal resistances were minimized. For … [Read more...]
Thermal Design Challenges in Automotive Alternator Power Electronics
Ever since the advent of the automotive alternator, or claw-pole alternating current generator, in the 1960's, there has been an ever-increasing thermal design challenge to cool the power electronics in these machines. Figure 1 depicts a typical cutaway section of a modern day alternator. At first glance one may think that cooling the diodes in a rectifier bridge of an … [Read more...]
The Thermal Conductivity of Thermal Insulators
This issue, we present an overview of a number of materials that are often used as thermal insulators. The world would have been much easier for thermal engineers if only the creator had provided us with a choice of materials showing the same range in thermal conductivity values as exists for electrical conductivity. Alas, this isn't the case. Thus, not a single one of the … [Read more...]
Flash Diffusivity Method: A Survey of Capabilities
The development, specification, and quality control of materials used in electronics packaging and thermal management often require the measurement of thermophysical properties.This data can be critical to a successful design, especially with the rapidly increasing cooling requirements that result from the packaging of higher performance devices. A variety of methods, involving … [Read more...]
- « Previous Page
- 1
- …
- 450
- 451
- 452
- 453
- 454
- …
- 481
- Next Page »
