Disk drive reliability and thermal management Hard disk drives are electromechanical systems which store information. They are the most complex electronic sub-assembly within a computer. If a microprocessor can qualify as the "heart" of a computer system, a disk drive can qualify as the "brain". Drives store and retrieve data in milliseconds, measured as access and transfer … [Read more...]
Cooling Electronics at High Altitudes Made Easy
Introduction High altitude air cooling has always been somewhat of a mystery to the uninformed. The first reaction to the situation is that there is just not enough air at altitudes greater than six kilometers (20,000 ft). At times this may be true, but many things can be done to improve the cooling and obtain an acceptable design. The most important thing to remember when … [Read more...]
Convection and radiation heat loss from a printed circuit board
In last issue's column, a method for calculating the thermal conductivity of a printed circuit board (PCB) was described. Now, we look at a more complicated heat transfer process, namely the loss of heat from the surface of a PCB to the ambient air. This situation is more challenging to describe mathematically since it involves the simultaneous processes of heat spreading by … [Read more...]
Thermal management of handheld telecommunication products
Introduction Recent advances in mobile communications have enabled large scale development of handheld telecommunication products. Such products include cellular phones, pagers, two-way radios, personal digital assistants (PDAs), and other wireless and wireline equipment. The technological enhancements at device, package, and system levels have resulted in increased … [Read more...]
Thermal interface under a plastic quad flat pack
Introduction Plastic components are designed so that the heat is dissipated by forced or natural convection. The use of plastic packages under conditions where neither cooling method is available introduces new challenges. High heat-dissipation plastic packages require a large-area solid heat sink in order to transfer the heat into the copper thermal lands on the printed … [Read more...]
- « Previous Page
- 1
- …
- 468
- 469
- 470
- 471
- 472
- …
- 482
- Next Page »
