The heat transfer coefficient is used to describe convective heat transfer between a solid and a fluid, as in Equation (1). The heat transfer coefficient is a defined parameter, not a physical property like thermal conductivity, and different definitions are used for different situations. The preferred definition for use in the electronics-cooling situation is … [Read more...]
Estimating The Effect Of Flow Bypass On Parallel Plate-Fin Heat Sink Performance
In past issues of Electronics Cooling, methodologies were presented for estimating parallel plate-fin heat sink thermal resistance [1] and pressure drop [2]. The underlying assumption for both articles was that all the flow delivered by the fan is forced to go through the channels formed between the fins. As noted in the second article this is often not the case and much of the … [Read more...]
Air Cooled Compact Heat Exchanger Design For Electronics Cooling
Introduction This article will discuss air-cooled compact heat exchanger design using published data. Kays & London's Compact Heat Exchangers [1] contains measured heat transfer and pressure drop data on a variety of circular and rectangular passages including circular tubes, tube banks, straight fins, louvered fins, strip or lanced offset fins, wavy fins and pin fins. … [Read more...]
The 45° Heat Spreading Angle – An Urban Legend?
Ever hear about the 45° heat spreading angle? Most of us have. However, no one I've talked to seems to know where it came from. Is it an urban legend, such as alligators in the sewers of Manhattan, or is it an eternal truth deposited into the collective subconscious of the thermal engineering community? However fascinating it might be to explore the historical origins of this … [Read more...]
Prediction of Thermal Contact Resistance
All engineering surfaces exhibit some level of microscopic roughness. The resistance to heat flow through a contact interface occurs because only a small portion (usually 1-2%) [1] of the nominal surface area is actually in contact. Heat may pass through the interface via three paths: conduction through the contact spots, conduction through the gas present in the gap between … [Read more...]
- « Previous Page
- 1
- …
- 141
- 142
- 143
- 144
- 145
- …
- 180
- Next Page »
