Introduction New thermal management solutions are needed to provide cost-effective means of dissipating heat from future generation microelectronic devices. A relatively new process to reduce the costs of fabricating large quantities of complex components, such as heat sinks, is metal injection molding (MIM), a net-shaping process in which metal powder is mixed with a … [Read more...]
Use Of Heat Pipe Cooling Systems In The Electronics Industry
Introduction Thermal management of electronic components must solve problems connected with the limitations on the maximum chip temperature and with the requirements on the level of temperature uniformity. To cool electronic components, one can use air and liquid coolers as well as coolers constructed on the principle of the phase change heat transfer in closed space; i.e., … [Read more...]
Opto-electronic Transceiver Modules, a System Design Perspective
Introduction Small Form Factor (SFF) optical transceiver packages for use at 1-2 Gbits/s data rates have been described by several authors [1-5]. These rely on dual miniature optical connectors such as the MT-RJ or the LC to provide optical-component case widths as small as one centimeter. Passive alignment of the optical fibers with the active optical devices is achieved with … [Read more...]
Critical Cooling Issues in High Power Radio Frequency Transmitter Amplifiers
Introduction While emerging methodologies correctly insist that thermal engineers should be involved right from the early conceptual stages of electronics product design [1], many situations still require thermal analysis well after the introduction of the product to its intended application. Military transmitters installed in the 1980's and 1990's and still in operation today … [Read more...]
Estimating The Effect Of Flow Bypass On Parallel Plate-Fin Heat Sink Performance
In past issues of Electronics Cooling, methodologies were presented for estimating parallel plate-fin heat sink thermal resistance [1] and pressure drop [2]. The underlying assumption for both articles was that all the flow delivered by the fan is forced to go through the channels formed between the fins. As noted in the second article this is often not the case and much of the … [Read more...]
- « Previous Page
- 1
- …
- 47
- 48
- 49
- 50
- 51
- …
- 58
- Next Page »
