All phase change thermal interface materials are designed to minimize the thermal resistance in an interface between a heat generating component and a heat sink. How well they achieve this goal in a specific application depends on how judiciously their phase change characteristics are matched to the interface specifications. The purpose of this paper is to present the results … [Read more...]
The thermal conductivity of aluminum oxide
Aluminum Oxide (Al2O3) is an important ceramic for the electronics industry. Besides its use as a passivation layer on Silicon, the ceramic is often used as a carrier for thick and thin film passive components and for other small printed circuit boards. A relatively low cost is combined with a relatively high thermal conductivity, especially when compared to FR4 board material. … [Read more...]
Thermal characterization of active components
In the European project SEED (Supplier Evaluation and Exploitation of DELPHI), the methods for thermal characterization of active components developed in the predecessor DELPHI (Development of Libraries of PHysical models for an Integrated design environment) were evaluated by component suppliers. The methods were improved for practical application and extended to a large … [Read more...]
Uncertainty analysis
Uncertainty analysis is the process of estimating the uncertainty in a result calculated from measurements with known uncertainties. Uncertainty analysis uses the equations by which the result was calculated to estimate the effects of measurement uncertainties on the value of the result. Uncertainty analysis is used in the planning stages of an experiment to judge the … [Read more...]
The thermal conductivity of pure metals
As discussed previously in this section, the measurement of the thermal conductivity is notoriously difficult. The consequence is that, while the measurement accuracy by individual researchers is claimed to be of the order of 2%, laboratories participating in round-robin tests produce results differing from each other by 15% or more [1]. Even the measurement of pure metals is … [Read more...]
- « Previous Page
- 1
- …
- 339
- 340
- 341
- 342
- 343
- …
- 354
- Next Page »
