Introduction Microprocessor and system thermal management are linked to facility cooling: power dissipation and cooling techniques employed at one end of the size scale have cascading impacts at the other extreme (Figure 1). For example, ineffective airflow distribution or insufficient underfloor static pressure in a data center can reduce the supply airflow rate from … [Read more...]
Air Cooled Compact Heat Exchanger Design For Electronics Cooling
Introduction This article will discuss air-cooled compact heat exchanger design using published data. Kays & London's Compact Heat Exchangers [1] contains measured heat transfer and pressure drop data on a variety of circular and rectangular passages including circular tubes, tube banks, straight fins, louvered fins, strip or lanced offset fins, wavy fins and pin fins. … [Read more...]
Hot Spots in Data Centers
Heat loads of data processing equipment continue to increase at a rapid rate. This increasing heat load has been documented by a Thermal Management Consortium of 17 companies [1] as shown in Figure 1. Also shown in this figure are measured heat fluxes (based on product footprint) of some recent product announcements. The most recent shows a rack dissipating 28,500 watts, … [Read more...]
Recognizing the Limits of Conventional Axial Hub-Motor AHS Devices
Conventional axial hub-motor AHS (Active Heatsink) devices (Figure 1) have reached their functional and cost limits and may not be improved significantly. These devices have a number of inherent, severe contradictions (design limitations) that determine the "evolutionary maturity" of this concept. Figure 1. Conventional axial hub-motor AHS. Let us look at different … [Read more...]
The Weakest Link in Air Cooling
So far, this 21st Century has been a big disappointment. I grew up on the science fiction of the 1950's and 60's. Plus I knew that the stories of Jules Verne and H. G. Wells had turned out to be amazingly accurate predictions of real technological advances. So I was expecting that, if I lived long enough to see the 21st Century (no way - I'll be in my 40's!), I'd be … [Read more...]
- « Previous Page
- 1
- 2
- 3
- 4
- 5
- 6
- …
- 8
- Next Page »
